FAQ - Page 2 Of 3 - Badge Artisans Co., Ltd

Question:What is the principle of spray painting? Answer: Compressed air atomizes liquid paint into fine droplets, evenly coating the product surface. Suitable for high-efficiency cus……

Question:What is the principle of electrophoresis? Answer: Charged paint ions migrate to the cathode under voltage, reacting with alkaline substances to form a non-soluble coating. Id……

Question: What is the principle of electroplating? Answer: Utilizes electrolysis to deposit a thin layer of metal or alloy onto a substrate surface. This enhances corrosion resistance……

Question: Why do fine textures occasionally fail to form on the cast blank? Answer: Excessive release agent application blocks intricate details, preventing zinc alloy liquid from fil……

Question: Why are sharp corners of the cast blank not fully formed? Answer: Insufficient die-casting machine pressure. Our factory selects appropriate tonnage machines based on produc……

Question: How to determine sprue location in mold design? Answer: Based on product shape and size. For zinc alloy medals, sprues are typically evenly spaced at four positions around t……

Question :Why remove sprue and flash from the cast blank? Answer: Sprue and flash are unnecessary by products of die-casting and must be cleaned and removed to meet custom product sta……

Question:What causes surface porosity on the cast blank? Answer: Poor mold venting. Adjust vent holes to improve exhaust efficiency. This is critical for maintaining high-quality cust……

Question: What causes water marks on the cast blank? Mold making Answer: 1. Insufficient mold surface finish; 2. Insufficient die-casting machine pressure; 3. Rapid startup speed caus……

Question:Why does a die-casting machine need to preheat a new mold when replacing it? Answer: Heating the new mold allows it to reach the required operating temperature, ensuring zinc……

Question: If the sprue of a blank is too thick, making it hard to peel off with a large sprue mark, how to solve it? Answer: A thick sprue results from an overly large sprue inlet dur……

Question: What causes cracks in blanks after die-casting? Answer: Cracks are caused by insufficient or unevenly distributed ejector pins (leading to uneven force) or deflection of the……

Question: What is used in the die-casting process to enable quick separation of blanks from the mold? Answer: Release agent. Our factory uses release agent to ensure blanks separate f……

Question:What is the raw material for zinc alloy die-casting, what are its models, and what are the material properties? Answer: Zinc alloy. Common models used are 3#, 5#, and 7#. As ……

Question:What are the commonly used software for drawing mold blueprints? Answer: Beijing Jingdiao is commonly used; some customers adopt Rhino for custom mold design.   design

Question: What machine is used for mold engraving, and what is its working principle? Answer: Mold engraving machine. The working principle: Our factory imports custom mold drawings a……